AI-assisted studio viewcs-product-025
Stainless steel flange plate
A stainless steel flange plate with a central bore and repeated mounting holes. Start with the bolt pattern, mating diameter and mounting-face requirements.
Explore component
Define the mounting face.
Flanges & covers
Machined mounting faces, hole patterns and covers for custom assemblies.
Explore 7 examples7 component examples
AI-assisted studio view
AI-assisted studio viewcs-product-015
Aluminum flange seat
An aluminum flange seat with a central bore and a patterned mounting face. Define the face datum and the location of holes and slots from that reference.
Explore component
AI-assisted studio viewcs-product-024
Stainless steel angled connector
A stainless steel connector with an angled body and round mounting features. Identify the mating faces, bore and critical hole positions for your version.
Explore component
AI-assisted studio viewcs-product-035
Aluminum flange coupling
A flanged coupling with a central bore, radial mounting holes and an extended end section. Define the shaft interface and flange datum before agreeing assembly checks.
Explore component
Original workshop photographcs-product-016
Acrylic container cover
A transparent acrylic container cover with a substantial circular body. Specify the mating geometry, internal features and required surface condition.
Explore component
AI-generated engineering conceptcs-product-063
Split clamping hub
A single-split hub concept for a shaft-mounted component: coordinate the bore, clamp screw path and mounting face as one assembly interface.
Explore component
AI-generated engineering conceptcs-product-056
Threaded sensor end cap
A short cup-shaped end-cap concept for a cylindrical instrument housing. Define the closure thread, locating shoulder and internal clearance as one assembly interface.
Explore componentWHAT DEFINES YOUR VERSION?
Start with the
functional features.
Use these examples to explain the geometry. Include a current dimensioned drawing to define the actual part.
Mounting face and hole-pattern datums
Define the mounting face and centre reference before dimensioning the hole pattern. Show whether the assembly locates on a bore, outside diameter, pilot or fasteners.
Sealing, flatness and surface requirements
Identify faces that seat or seal and state their actual requirements. Discuss flatness and surface condition with the part geometry; a general finish note does not describe every functional interface.
Fastener clearance and assembly access
Check fastener access, counterbores and clearances in the assembled condition. For a cover, include the mating envelope and the requirements for removing or fitting the part.
FROM EXAMPLE TO YOUR REQUIREMENT
Found something
close to your part?
Send your drawing
Use an example to explain your idea.
Your own drawing defines the final specification.
New ABS product references
Original product photographs and drawing-led enquiries for distinct geometries.